Diameter 325mm Of Cement Screw CZPT For Coal,Sand,Silo
- The LSY series screw conveyor is a new variety of transportation tools, which is mainly used for transporting cement, fly ash material in concrete mixing station and other appropriate areas.
- It can also be utilised in chemical, metallurgy, granary processing, warehousing.
- it can also match with other transportation equipment to attain joint transportation or independent transportation.
|Screw pace(r/min)||two hundred|
Screw conveyor composition:
Feeding inlet, discharge outlet, motor, retarder, bearing, helical blade, closed groove, hanging bearing, bearing spiral,universal joint, suction flange, outer tube, connection flange, observation window, etc.
The Composition Diagram
one.It is relevant to transport various kinds of loose material this kind of as electrical electrical power, granular and little-piece materials these kinds of as clay powder, braize, cement, sand, grain, tiny coal briquette, cobble and iron filings, and so on.
two.Screw conveyors is not relevant to transportation substance which is high viscosity and simple to be curdled.
3.The proper ambient temperature for screw conveyor is 20ºC to 50ºC. The materials temperature must be less than 200ºC.
- Adopt high-top quality steel pipe with good integral rigidity.
- Adopt optional universal ball joint, which facilitates installation, adjustment and steering.
- With higher-top quality reducer and heavy-design and style, it has the advantages of large torque, low sound, no dust leakage, long service life.
- The design of double pitch for reducing the compress extent of the substance in transportation, is especially suitable for prolonged-distance transportation of cement and other powder supplies.
- .Large inventory for common diameter of 219,273,and dimension & angle can be CZPT according to your
When the screw shaft rotating, the gravity of the substance and the friction power produced by the materials and trough wall enable the material shift CZPT along the bottom of the conveyor with the thrust of blade. The conveying of materials in the center bearing relies on the CZPT thrust of hinder materials. The screw conveyor promote the material to go CZPT by the fastened screw’s rotational motion and rectilinear movement.
Set up adjustment:
1.The screw conveyor can not be installed until the dust stuck during transportation or
unloading is cleaned.
two.Substance groove centre line and screw shaft should have an appropriate coaxial degree.
3.The junction of each and every section of the materials groove should be connected closely and can not be dislocated. The spacers can be included in between the joint and the section, the top include and the material groove, to guarantee the seal of materials groove. Meanwhile the size mistake of the substance groove can be altered.
4. The space between the interior wall of the material groove and the screw must be equivalent.
five.The travel device and the screw shaft need to have a right coaxial degree. You can alter the peak of the generate system by adding spacer .
6.The static equilibrium take a look at must be carried out following the screw is mounted.
seven.After the conveyor put in, check whether there is any debris in the machine and if the lubrication is ample.
(1) Lubricate the bearings, gears, chains and other transmission parts regularly.
(2)When the box-to-deliver machine stopped, check out the abrasion of the spiral blade and restore and weld it when it wears seriously.
(three)The conveying amount can not be overloaded, otherwise the material will not be discharged, which could cause the screw shaft bending and box growth.
(4) In the procedure of the conveyor, if the sounds is severe, you should open up the lid to check it and troubleshoot.
Make contact with:
HangCZPT TRUSEEN CZPT CO,.LTD
Tel: -371-86238892 Mobile telephone:15617732826
Include:HangCZPT Large-tech CZPT CZPT Zone,ZheJiang Province,P.R.China