Manual and Diesel Engine Chain Diassaembling DTH Hammer Tools
Products Feature
DTH Hammer Loosening Resources: The threaded connections of the driver chuck and top sub may become very tightly tensioned during drilling.It is convenient to break the hammer threads on the rig, but if the threads cannot be loosened or tend to get stuck, a DTH Hammer Assembling products is the solution.
This handy but powerful DTH Hammer Loosening Equipment / DTH Breakout Bench
can easily be placed in a workshop or container and it breaks DTH hammers between 3.5”-8″.
There are two sorts of bench to disassemble the dth hammers.
Guide:
The operation strategy as underneath:
one). Put hammer on the bench.
two). Modify the position of the hammer and wrench use wrench to block the prime sub side of hammer let wrench and jack in the exact same encounter.
three). Correct K-formed foundation with nut.
four). Repair wrench with nuts.
5). Shake deal with of jack little by little till best sub absent from hammer.
six). Right after leading sub dismantled, grease the jack, launch nuts, discharge the K-formed base and flip about the hammer.
7). Change the situation of hammer and wrench use wrench to block the push chuck of hammer enable wrench and jack in the very same experience.
8). Fix hammer
nine). Resolve K-shaped base and the wrench with nut.
10). Shake take care of of jack little by little till travel chuck away from hammer.
CZPT
The regular motor request electricity resource with 3phase, 380V,50Hz. we can modify the motor as clients ask for.
Specifications
one. for disassembling the dth hammer
two. straightforward operation
3. minimal cost
four. for 3″ to eight” hammers
Primary CZPT Information
Functioning principie | by hydraulic jack (guide) |
by electric powered motor | |
Product | CX-five | CX-eight | ECX3-8 |
Operate hammers | 3-five” | six-8″ | 3.5-8″ |
Duration | 920mm | 1100mm | 1060mm |
Width | 510mm | 620mm | 930mm |
Height | 875mm | 875mm | 1050mm |
Weight | 350kg | 350kg | 800kg |